I have noticed that my home server is strangely using lots of swap (~5 GB), despite having only a few lightweight processes running and loads of RAM installed (32 GB).
Upon configuring Grafana + Prometheus, I noticed a trend where cache + buffer will progressively increase until swap starts to be used. My system and services combined will use ~8 GB RAM. Upon rebooting, the cache + buffer will start anywhere from 3–10 GB, progressively ramp up to ~25 GB in 1–2h, where swap will start to be needed (~3 GB). See the image attached for reference.
My swap filesystem is on an expensive (to me) SSD, and I would like to reduce its wear by as much as possible. I understand that swap can introduce only minimal wear on SSDs depending on its nature and that it can be harmless, but I am still not sure what is causing this behavior (and why) and whether I should worry about it or not. So I figured I should investigate what is happening here.
My main question is, how can I figure out what is causing this behavior? Is it expected? I am looking for guidance from others who are more experienced than me in the topic.
A little bit about my system:
I am running Debian 12 on an NVMe SSD containing the root partition (btrfs) and docker services. I also have two HDDs, one with persistent data (ext4), and the other with backups (ext4). This is majoritarily a single-user machine. I tried using the following kernel parameters, but it hasn’t helped:
vm.swappiness=10
vm.vfs_cache_pressure=200
My docker services are:
- *arr stack
- jellyfin
- nextcloud
- immich
- open-webui + ollama
- pi-hole
- invidious
- romm
- nginx proxy manager
- grafana + prometheus
- other minor services that I don’t think are doing much (uptime-kuma, stirlingpdf, vaultwarden, etc)
It’s “free ram” until stuff actually goes in swap.
It depends on the scenario, of course. Maybe you have huge, totally idle processes, and active ones working from an HDD that need cache desperately, in which case this is good.
But my experience with Linux is that is waaay to aggressive with this, in most configs, and I get far better performance from configs that avoid swap until it absolutely has to be used.
Every use case is different and there is when you can customize it being Linux.
So good, sladapt your swappines and/or ditch swap completely or try zram, according to your needs. Standard use case works fine for most people tough.